Blasterforge STINGER

Required materials:
-2 motors
-2 microswitches
-Arduino smartcar gearbox

Instructions:

1. Print all parts except Tube.stl
2. Epoxy clear Rightshell2 to Rightshell
3. Do wiring, lipo connector goes into the rectangle hole towards the battery bay
4. install other components
5. Fuse left shell2 with left shell using epoxy
6. Epoxy half of the Top rail to left OR right side.
7. Print Tube.stl in ABS!!!! Then sand the inside of the tube and stick it in and glue in place.
8. Print Nerf Stock Port.stl 2x but the other is mirror inverted
9. Glue them onto the back of the blaster to form a nerf stock attachment point
10. pew pew pew!