WayMaker

The WayMaker is a HPA 'Nerf' blaster designed for CQB and mid-range engagements, with a ‘mag in grip’ design to make this semi auto blaster short and light to use.

It is powered by a SUPERcore and fed by worker Talon mags.
With much of the weight behind the grip the blaster feels light when maneuvering this added to the short length makes the blaster easy to use in confined spaces.
The stock can be set to different lengths by re-positioning the screws onto the body.
With the quick disconnect at the back it keeps the airline close to your body and can be tucked away with a well positioned bottle on your rig.

With the shown barrel length at 170mm, the FPS is around 170-180 @85psi falling to 130-140 @65psi the barrel used for these tests is a Monkee Mods threaded one that has been cut to length.

Warning
This shell and the HPA system it uses, are for use by those who are familiar with air powered blasters, and its use should be limited to private nerf games due to its looks and power.

The parts you need to print:

• Handle (Secondary colour)
• Nose (Primary colour)
• Front body (Primary colour)
• Mid body (Primary colour)
• Rear body (Primary colour)
• Valve holder (Primary colour)
• Body end cap (Primary colour)
• Quick disconnect support (Primary colour)
• Trigger (Primary colour)
• Trigger slide (Hidden item)
• Slide runner (Hidden item)
• Dart spring (Primary colour)
• Front bottom picatinny (Secondary colour)
• Side picatinny x2 (40, 60 or 80 mm) (Secondary colour)
• Top picatinny (Secondary colour)
• Stock (Secondary colour)
• Stock butt plate (Secondary colour)
• Dart ramp (Early SUPERcores may need this) (Hidden item)

Other hardware you need

• SUPERcore from SpectreArmaments (facebook)
• Quick disconnect from herbmeister_nerf (instagram)
• Threaded monkee mods barrel (cut to length)
• 6mm flexible hose
• MJVO-3 valve
• Banjo pushfit connector x2
• Threaded pushfit x2

Tools

• Screwdriver
• Hobby knife
• Spanner
• Teflon tape
• 2mm drill bit
• 3.5mm drill bit
• Drill
• Small file

TODO’s

Make stock adjustable with retention system not screws
Add longer nose option
Add scarpressor

Post Print

Remove built in supports from trigger guard on the handle and dart jam hole on the mid body.
Clean up parts from stringing and other print artifacts