An adjustable batter stock for any nerf stock attachment point. Not all files are in proper print orientation.
Notes:
1) Stock is adjustable using a 1/4 quick release pin (1 3/4" long).
2) Butt attaches using two m3 heat set inserts in the stock body and two m3 x 20 button
cap or socket cap screws.
3) Stock catch uses two small springs and four #3 x 3/8".
4) If you would like to print a TPU butt pad, use one of the butt plates and one of the two
separate butt files.
5) You should print a mirrored version of both color plates as well as the originals.
6) The cheek rest used two m3 nuts and two m3x25 button cap screws. You can also use
two #4 x 3/4" screws if you wish.
7) Rotate Stock body and cheek rest 180 degrees for proper print orientation. Buffer tube
is in proper orientation. Rotate others so they lay flat on eh print bed.
8) Color plates and but pads are glued on to their respective parts.