3D printable clip for the Nerf Zombie Strike Nailbiter. Holds ten darts and is easily removable from the blaster. There are three variations; one with dart stops at the back of barrels, one without stops to enable rear loading, and finally one with barrels that accept 17/32 brass tubing (untested as of time file release). The clip may need minor sanding or cutting to fit but should be fine straight of the printer. Some minor cutting is also required on the top portion of the blaster where the clip is inserted.
1/6/2019, 7:19 PM PST; Original files have been replaced with V2.1 files. Original files have been removed.
1/6/2019, 9:00 PM PST; V2.1 replaced with V2.2. Clip made slightly taller so that it wobbles less in the blaster and is less likely to fall out of the blaster.
DISCLAIMER: As of now, the files have not been tested. I have tested a previous version but have made changes since. Therefore I cannot guarantee that these will function as intended. I am planning to print the current version asap.
I cannot guarantee that these will function with the stock blaster but I do not foresee any issues.
