hello there !
this is a kit that extends the barrel for the nerf bigshock to make it look better, even for a really cheap blaster... this doesn't increase fire power, just gives you about one extra meter of range ...
this is a reaally easy thing to print so you should give it a try !
installation instructions :
this should be a drop in kit but some sanding may be required to make it fit nicely on your blaster :)
you'll need :
-1x M4/M5 screw (M4 is the best)
-1x Maching nut (m4 if you got m4 screw & vice versa)
-1x Matching screwdriver (quite long is the best)
-1x the printed piece
-1x Nerf bigshock
-1x sanding paper ( not useful in most cases)
-step 1 remove supports ( if present)
-step 2 press fermly the printed piece against the front of the gun while keeping everything in line
-step 3 insert the nut in his slot on the top of the printed part
-step 4 insert the screw through the storage hole through the front face of the nerf
-step 5 tighten the screw
-step 6 you are done ! GG !
don't forget to add a "make" if you printed this !