Reload quick and efficiently with this speed loader design for the Nerf Rival Kronos blaster.
Steps to assemble:
1) Insert slide in to housing
2) Super glue cap to top of housing
Recommended print settings:
- Layer height: <= 0.1 [mm]
** Layer resolution is critical. Tolerances are tight for being a 3D printed part - Print speed: <= 35 [mm/s]
- Infill: >= 15 [%]
- Print with skirt
Here is the door for the assembly.
https://www.thingiverse.com/thing:2826909
The reason I did not create my own is because I used hi-sol to adhere the T handle and already had this mod. I was never planning on taking this apart again, but it looks like I spoke too soon!
Designed in OnShape.