Bezel mount for AmmoCounter V3 Kits available at http://ammocounter.com
IMPORTANT - This print requires a standalone AmmoCounter V3 kit.
- Print the bezel with supports and buttons.
- Trim any loose plastic with a hobby knife.
- Insert buttons, they should slide freely. If not, repeat step 2.
- Install the V3 kit by pressing into the back of the bezel mount.
- Cut a hole 30mm width x 32mm length in your Nerf blaster or accessory.
- Insert finished bezel mount assembly.
Printed at 35% infill and 2 shells on a Makerbot 5th generation.
Please do not sale this design or any remix without written permission from AmmoCounter.
Contact us at http://facebook.com/AmmoCounter with questions!